Heated Floor Thermostat Instructions
Heated Floor Thermostat Instructions. This thermostat is suitable for electric underfloor heating systems only. Any other cable on the floor and must be embedded in the cementituous based mortar in the same manner as the heating cables.
Cut off power supply on lead wires at the electrical panel in order to avoid any risk of electric shock; Any other cable on the floor and must be embedded in the cementituous based mortar in the same manner as the heating cables. When the thermostat senses a need for heat, the circuit through the thermostat is closed and 24 volt ac signals the relay to close the 110 volt circuit to the pump.
When The Thermostat Senses A Need For Heat, The Circuit Through The Thermostat Is Closed And 24 Volt Ac Signals The Relay To Close The 110 Volt Circuit To The Pump.
Controls the floor temperature using an external temperature sensor af mode: • prepare the thermostat for installation: 8 rows °f or °c.
• The Floor Temperature Sensor Wire Can Be Extended To A Maximum Of 50 Feet With Ul Or Csa Recognized Wire 22 Awg Rated For 300 V.
Press day/week/year to view the different time ranges. 4.7 out of 5 stars. Controls the ambient air temperature maintains the floor temperature within desired limits using an external temperature sensor operating modes 2.
Turn The Heating System Off At The Main Electrical Panel.
(the screw cannot be completely removed.) p connect the thermostat to the load and to the power supply (see page 7). Thermostat should be located 1.5 m (5 ft) above the finished floor. Sunstat command floor heating thermostat, programmable.
Ensure That The Thermostat Will Be Installed On A Junction Box Located In An Uninsulated Wall;
Press the ‘day’ button as many times as necessary to set the thermostat to the correct day. 4.5 out of 5 stars. When you purchase an electric floor heating system from warmlyyours, you can choose from a selection of different controls and thermostats that will meet your specific needs.
Thermostats Shown Are Compatible With Both Lx Mats And Lx/Tx Cables.
Thermostat mounting and connection 1. The thermostat cycles the heating on and off to maintain the desired setpoint temperature. O loosen the bottom screw and remove the thermostat faceplate from its wallplate.
Post a Comment for "Heated Floor Thermostat Instructions"